Electrode Holder

An Electrode Holder, commonly known as a stinger, is a clamping device for holding the electrode firmly in almost any position. The welding cable attaches to the holder during the hollow insulated grip. The plan of the electrode holder enables quick and effortless electrode exchange. Two general kinds of electrode holders have been in use: insulated and noninsulated. The noninsulated holders aren't recommended as they're subject to casual short circuiting if bumped from the job - piece throughout welding. For security reasons, attempt to make sure the use of just insulated stingers on the jobsite. Electrode holders are made in different sizes, and Electrode Holder Manufacturer have their own system of designation. Each holder is designed for use within a specified range of electrode diameters and welding current. You require a larger holder when welding with a machine having a 300-ampere rating than when welding with a 100-ampere machine. If the holder is too small, it will overheat. The use of a good Earth Clamp is also essential to producing quality welds. Welcome to call us at any time.

Please Note that this information was issued on BestB2B.com!

Insulation Panel,roof panels2024-01-29

EPS sandwich panel2024-01-29

Insulated Metal Panels Increas2024-01-29

Insulated Metal Roof Panel2024-01-29

Light Insulated Metal Wall Pa2024-01-29

Insulated Metal Wall Panels2024-01-29

Insulated sandwich panels / In2024-01-29

Trapezoidal Roof Panel / Wall2024-01-29

100G QSFP28 SWDM4 100m LC Opti2024-02-01

100G QSFP28 SR4 100M MPO Optic2024-02-01

200G QSFP56 SR4 100m MPO Optic2024-02-01

400G OSFP SR8 100m MPO Optical2024-02-01

400G QSFP-DD LR8 10KM LC Optic2024-02-01

400G QSFP-DD LR4 10KM LC Media2024-02-01

400G QSFP-DD 4x100G LR 10KM 2024-01-29