Resistance Spot Welder Small AC Butt Welder Wholes
ID:593408 View:482次 | Collection |
Date Listed: | 2022-08-06 15:48:35 | Country: | China»Hebei»hengshui |
Poster: | mash welder | Company: | Hengshui jinshida Machinery Manufacturing Co., Ltd |
Location: | Wuqiang County, Hengshui City, Hebei Province | Website: | Hengshui jinshida Machinery Manufacturing Co., Ltd |
Email: | xyw2022@hsjsd.cn | Mobile: | |
Fax: | MSN: |
In order to ensure the normal operation of this welding machine, the welding machine should be placed in a place that is ventilated, dry, free of moisture, dust, acid, alkali and salt corrosion, and free of large vibrations. The ambient temperature should be -10℃ - +30℃, relative Use in an environment where the humidity does not exceed 65%. When the environmental conditions do not meet the above requirements, it may affect the normal operation of the equipment. In severe cases, it may cause failure of the welding machine and welding controller and delay the use of the user. The main engine of this welding machine can be placed on a relatively flat ground. If possible, it is better to use anchor screws to fix it, which can increase the working stability of the welding machine. Affect welding power and welding effect. The power supply used by this welding machine should meet the requirements of power supply voltage and frequency. Necessary protective measures should be taken when there are high-frequency electrical equipment near the welding machine. When the voltage fluctuation range of the power supply is relatively large, the welding quality of the workpiece may be affected. Because the welding power of the welding machine is relatively large, the corresponding knife switch and power cord must be installed in accordance with the requirements of Table 5. It is best for the welding machine to use an automatic air switch with leakage protection and overload protection device alone. Do not easily increase the knife The capacity of the switch fuse and the use of copper wire instead of the safety fuse, otherwise, when the welding machine fails, it will not have the proper protection, and it may even burn out the welding transformer and the control part of the welding machine. The power cord used should be made of copper conductors no smaller than the data in the table. In order to ensure the normal operation of the welding machine and the personal safety of the
Please Note that this information was issued on BestB2B.com!
High Quality TC TG TB Oil Seal NBR FKM ACM VMQ Oil2024-02-03
costa rica liquid nitrogen sample storage tank 2024-02-02
NQKSF Oil Seal Brand New High Quality FKM Seals2024-02-01
Syria nitrogen semen tank KGSQ five-wheeled cart2024-01-31
Honduras large diameter liquid nitrogen container2024-01-29
Wholesale Good Quality NQK O Ring Seals2024-01-29
Charging market environment continues to evolve2024-01-29
EVs High Voltage Cable Development Thread2024-01-29
China supply Support ring FK4E39-K for power plant2024-01-29
Lock nutboiler feedwater pump HPT200-330M for powe2024-01-29
China Manufacturer Respirator DG600-240-05-15-00 f2024-01-29
China made Hu bevel gear 0130/0010/0140 for steam 2024-01-29
Liquid-cooled cables for EV high-power charging2024-01-29