injection mold product design

See hot tip radius of the area if there is fracture.The machine is left in the fracture heat hardened plastic mouth loose debris from the cartridge by the holding force in the forward component caused by the injection mould.Cause of the problem is also possible that the center line is not aligned.When the fracture was found to consider both possibilities.If you have suffered serious damage to not prevent leaks when petal-shaped(a term previously used molds user refers to the mouth between the thermal head in the emergence of the guide sleeve and plastic machine leak),it should be replaced gate sets at injection mould.

Please Note that this information was issued on BestB2B.com!

Insulation Panel,roof panels2024-01-29

EPS sandwich panel2024-01-29

Insulated Metal Panels Increas2024-01-29

Insulated Metal Roof Panel2024-01-29

Light Insulated Metal Wall Pa2024-01-29

Insulated Metal Wall Panels2024-01-29

Insulated sandwich panels / In2024-01-29

Trapezoidal Roof Panel / Wall2024-01-29

100G QSFP28 SWDM4 100m LC Opti2024-02-01

100G QSFP28 SR4 100M MPO Optic2024-02-01

200G QSFP56 SR4 100m MPO Optic2024-02-01

400G OSFP SR8 100m MPO Optical2024-02-01

400G QSFP-DD LR8 10KM LC Optic2024-02-01

400G QSFP-DD LR4 10KM LC Media2024-02-01

400G QSFP-DD 4x100G LR 10KM 2024-01-29